Clarke 6462199 운영 및 유지보수 지침 매뉴얼 - 페이지 12

{카테고리_이름} Clarke 6462199에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 6462199 17 페이지. Multi function tool

USING THE SCRAPER

The scraper is used to remove paint, sealant, adhesives and vinyl/fabrics from

a workpiece.

1. Hold the tool tightly and move the

On/Off switch forward.

2. Put the tool against the workpiece

at a low angle and apply light

pressure to the scraper blade.

• Let the tool to do the work and

do not apply excessive

pressure, which can cut into

the surface and overload the

tool.

NOTE: The scraping blade is designed for scraping soft materials from flat

surfaces.

NOTE: The scraper blade is sharp and can dig into the surface of soft

materials such as timber in the same way as a chisel.

USING THE SAW ATTACHMENT

The saw attachment is used to cut materials such as wood, plastics and sheet

metal such as aluminium.

CAUTION: CLAMP THE WORKPIECE SECURELY IF POSSIBLE BEFORE

STARTING WORK.

CAUTION: ALWAYS CHECK THAT THERE ARE NO NAILS OR SCREWS IN THE

WORKPIECE BEFORE CUTTING.

NOTE: Ensure the blade is sharp and not damaged before starting work.

SAWING WITH THE STRAIGHT BLADE

1. Hold the tool tightly and move the

On/Off switch forward.

2. If making a plunge cut use a slight

pendulum motion to allow chip/

debris removal.

NOTE: Plunge cuts should only be

attempted on soft materials

such as softwood and

plaster boards.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]