Clarke CONTRACTOR CLJ120 운영 및 유지보수 지침 매뉴얼 - 페이지 6

{카테고리_이름} Clarke CONTRACTOR CLJ120에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CONTRACTOR CLJ120 8 페이지. Lock jig

Using the Jig

Depending on the size of lock to be fitted etc, all that is required is to mark on the door

edge the centre line of the lock position. As a general guideline the centre line would

normally be 1 metre from the bottom of the door.

Once the lock position is determined, mark the centre

line across the door edge (Fig. 5). This mark is used to

position the jig in the correct place for routing.

Loosen both wing screws and turn levers fully

anticlockwise.

Place the jig on the edge of the door, slide into position

so that the centre line on the jig lines up with the marked

centre line on the door edge (Fig. 6).

Turn levers fully clockwise and secure in position by

tightening both wing screws (Fig. 6a), DO NOT overtighten.

Check Jig is in the correct position, once satisfied, carefully

secure the jig to the door edge using suitable woodscews

in the securing holes (3mm ø) top and bottom of the jig.

Securing Holes (3mm ø)

Fig. 6

Securing Holes (3mm ø)

-5-

Before continuing, check that the

centre line on the door is still lined

up with the centre mark on the

nesting plate, if not adjust until it

does.

Fig. 6a

NOTE: when selecting inserts, take

into account the aperture will cut

approx 1.65mm smaller all round. If

in doubt test on a piece of scrap first.

Fig. 5

Centre Line

Dotted line showing

lock position