Clarke CONTRACTOR CLJ120 운영 및 유지보수 지침 매뉴얼 - 페이지 7

{카테고리_이름} Clarke CONTRACTOR CLJ120에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CONTRACTOR CLJ120 8 페이지. Lock jig

Fig. 7

1. Set the router to cut to the thickness of the lock plate + the lock body plate.

2. Position the router onto the jig ensuring the cutter is not touching. Switch the router ON

and plunge to the full preset depth and rout in a clockwise direction until the recess is

completely cut. Switch the router OFF and wait for it to come to a full stop before

lifting it from the jig.

3. Loosen the insert securing screw and remove the insert, DO NOT move the nesting

plate. Square out the recess corners using a sharp chisel.

4. Fit other insert with smaller aperture (lock body) into the nesting plate and secure in

position with locking screw.

5. Set the router to plunge to a maximum depth of 10mm, position the router on the jig as

before. Switch ON and plunge to the full preset depth and rout in a clockwise direction

until the recess is completely cut. Switch the router OFF and wait for it to come to a full

stop before lifting it from the jig.

6. Increase the depth of cut a further 10mm and repeat step 5.

7. Continue to repeat steps 5 & 6 until the required depth is reached, IMPORTANT never

exceed 10mm depth of cut.

8. When the required depth is achieved, switch the router OFF, wait for it to come to a

complete stop, remove the router and store safely.

9. Loosen the insert securing screw and remove the insert, square off the recess corners

using a sharp chisel.

Select the correct pair of

inserts for the lock to be fitted.

Fit the Insert with the largest

aperture (lock plate) into the

nesting plate and secure in

Fig. 7a

place with locking screw (Fig.

7 & 7a), ensure the insert sits flat

in the nesting plate.

-6-