3D AEROWORKS Pilatus PC-21 조립 설명서 및 사용자 설명서 - 페이지 15
{카테고리_이름} 3D AEROWORKS Pilatus PC-21에 대한 조립 설명서 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D AEROWORKS Pilatus PC-21 19 페이지.
페이지 인쇄
BALANCING AND CG
22
The ballast lead required should be placed in the hollow section of fuse 1. NOTE! Balancing
needs to be done with the propeller attached. See below
Fit the battery using Velcro as required and balance the aircraft inverted on the CG marking
points located 60mm aft of the leading edge at the wing root.
Once balanced appropriately, glue Fuse 1in place with ca.