3D Hobby Shop Edge 540 조립 설명서 - 페이지 14

{카테고리_이름} 3D Hobby Shop Edge 540에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Hobby Shop Edge 540 17 페이지.

The cowl is installed with 4 small wood screws which screw into 4 small square plywood pads at the

extreme front of the fuselage. Use small pieces of tape or paper as indicators to show the position of

these plywood pads after the cowl is on.

Install the canopy hatch (if the canopy hatch is not installed when you fit the cowl, it may be

impossible to fit the canopy hatch after the cowl is installed!).

You can use a 1/16" or smaller drill bit to drill these holes in the cowling, but the preferred method is to

spin a sharp hobby knife blade to make these holes as shown. This gives precise control of the size of

the holes and does not open the holes in the plywood pads too large.

Remove the cowl, use a drop of thin CA to harden the hole in each plywood cowl-mounting pad, and re-

install the cowl with 4 small wood screws.