3D Hobby Shop Edge 540 조립 설명서 - 페이지 16
{카테고리_이름} 3D Hobby Shop Edge 540에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Hobby Shop Edge 540 17 페이지.
16
Again, if you are not sure of the servo arm length you need, delay locking the adjustor nut so that you can
move the adjustor on the arm if necessary.
VELOX VR-1 ONLY - Install the SFGs onto the wing tips as shown using 2 large wood screws each.
Place the SFG spacers in between the SFGs and the wingtips to space the SFG away from the aileron to
avoid interference. Use a hobby knife to open the screws holes in the covering on the wingtips. Be
careful inserting the screws through the SFGs into the wingtips, make sure they are centered to avoid
damaging the wingtip internal structure.
Mounting the receiver: In your kit is a rectangular piece of lightweight balsa wood marked "Rx". You can
attach your receiver to this plate with double-sided tape, velcro, or glue and mount the plate in any
convenient location inside the fuselage.
EDGE 540 ONLY - Use thick CA glue or tape to attach the landing gear cover plate as shown: