3D Hobby Shop Edge 540 조립 설명서 - 페이지 15
{카테고리_이름} 3D Hobby Shop Edge 540에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Hobby Shop Edge 540 17 페이지.
15
Hinge the ailerons onto the wings using 2 large drops of thin CA on each hinge.
Remove the covering over the aileron servo locations and the aileron control horn slots as shown.
Install aileron horns into the ailerons using a generous amount of thick CA glue. Assemble the aileron
pushrods as you did the elevator pushrod. Attach a 6-8" (200mm) servo extension to each aileron servo.
Use heat shrink tubing of a servo plug lock on this connection. Use the included string to pull the servo
wire through the wing and install the servo, servo arm, adjustor and pushrod just as you did on the
elevator. After installation, the pushrod may be trimmed to length.