3D Hobby Shop EPP EXTRA 330SC 조립 설명서 - 페이지 5

{카테고리_이름} 3D Hobby Shop EPP EXTRA 330SC에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Hobby Shop EPP EXTRA 330SC 15 페이지. Arf rc

On to the fuselage, remove the elevator from the horizontal stabilizer. Insert the elevator in the slot for the horizontal

stabilizer. You will find it is easier if the elevator is upside down and backwards as shown.

The elevator can then be turned over once installed in the slot.

Locate the carbon wing spar tube and insert it into the fuselage. The carbon tube is NOT to be glued in, it

is to remain removable. Insert the horizontal stabilizer into the fuselage as shown. Measure from the

tube to the stabilizer on both sides of the fuselage as shown to make sure the stabilizer is straight.

Measure the stabilizer side-to-side to make sure it is centered. Also, look from the rear to be sure the horizontal stabilizer is

parallel with the wing tube.