3D Hobby Shop Velox VR-1 조립 설명서 - 페이지 3

{카테고리_이름} 3D Hobby Shop Velox VR-1에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Hobby Shop Velox VR-1 17 페이지.

3
Covering Material –
Your airplane is covered in genuine Oracover covering material. If you ever need to purchase additional
covering, Ultracote brand covering is an exact match.
Removing covering –
Use a new sharp blade in your hobby knife when removing covering over the access holes in the
airplane. You can also use a hot soldering iron, or a "hot knife" to remove covering if desired. Note that
covering material cuts easily, but rapidly dulls knife blades. To achieve clean cuts, change the blade
often. Remove the covering over the access holes in the fuselage as shown:
R
emove covering for the horizontal stabilizer, and for the elevator servo – NOTE only remove covering
for the elevator servo on ONE side of the fuselage.