3D Hobby Shop Velox VR-1 조립 설명서 - 페이지 4

{카테고리_이름} 3D Hobby Shop Velox VR-1에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Hobby Shop Velox VR-1 17 페이지.

Remove covering on the bottom of the fuselage as shown for motor/battery cool air exit:

Assemble the wheel onto the aluminum wheel axles, fix with wheel collar, and slide axle assembly into

wheel pant as shown.

Assemble axle, wheel and pant onto landing gear leg as shown. Note that the carbon gear has a "front"

and "back" orientation, check the gear against the fuselage to find the "front" side. Slide the axle thread

through the gear leg. Apply locking nut. NOTE – The nut is self-locking. It will not "spin" onto the axle

thread easily. You will need to hold the axle with needle-nose pliers and tighten the nut as shown.