3D Hobby Shop YAK55 조립 설명서 - 페이지 11
{카테고리_이름} 3D Hobby Shop YAK55에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Hobby Shop YAK55 19 페이지.
페이지 인쇄-- Install the tail wheel onto the wire, making sure the wheel rotates freely tighten the set screw with a 1.5mm hex tool as
shown below.
-- Insert aileron into wing panel making sure to align the end of the aileron with the wing tip.
-- Making sure that the aileron can deflect 45 degrees in each direction freely and glue the hinges with a couple of drops
of thin CA on each side. NOTE: it is recommended to glue the inside hinge, re-check the aileron motion, and then glue
the hinge near the wingtip followed by the hinges in the middle.