3D Hobby Shop YAK55 조립 설명서 - 페이지 10

{카테고리_이름} 3D Hobby Shop YAK55에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Hobby Shop YAK55 19 페이지.

-- Insert the rudder into the fuselage, make sure it swings 45 degrees in both directions, and glue the hinges with a

couple of drops of thin CA from each side as shown.

-- Slide the tail wheel bracket over the wire and screw the wood screws into place through the bracket as shown below.

Make sure that the rudder swings freely.

-- Remove the screws to apply thin CA to the screw holes.

-- Screw the bracket back into place after the thin CA has cured.