- ページ 10

おもちゃ 3D Hobby Shop YAK55のPDF 組立マニュアルをオンラインで閲覧またはダウンロードできます。3D Hobby Shop YAK55 19 ページ。

-- Insert the rudder into the fuselage, make sure it swings 45 degrees in both directions, and glue the hinges with a

couple of drops of thin CA from each side as shown.

-- Slide the tail wheel bracket over the wire and screw the wood screws into place through the bracket as shown below.

Make sure that the rudder swings freely.

-- Remove the screws to apply thin CA to the screw holes.

-- Screw the bracket back into place after the thin CA has cured.