3D Hobby Shop YAK55 Montagehandleiding - Pagina 11

Blader online of download pdf Montagehandleiding voor {categorie_naam} 3D Hobby Shop YAK55. 3D Hobby Shop YAK55 19 pagina's.

-- Install the tail wheel onto the wire, making sure the wheel rotates freely tighten the set screw with a 1.5mm hex tool as

shown below.

-- Insert aileron into wing panel making sure to align the end of the aileron with the wing tip.

-- Making sure that the aileron can deflect 45 degrees in each direction freely and glue the hinges with a couple of drops

of thin CA on each side. NOTE: it is recommended to glue the inside hinge, re-check the aileron motion, and then glue

the hinge near the wingtip followed by the hinges in the middle.