CubuSynth Exhaust 빌드 매뉴얼 - 페이지 6

{카테고리_이름} CubuSynth Exhaust에 대한 빌드 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CubuSynth Exhaust 12 페이지. Expander module for the engine
CubuSynth Exhaust에 대해서도 마찬가지입니다: 사용자 설명서 (5 페이지)

페이지 인쇄

CubuSynth Engine - Build Guide

PCB V1.1 Jul 2022

STEP 5 (Main PCB)

Transistor

Take the 2N3904, put it in place and make sure the orientation is correct. The outline of the

transistor has to match with the silkscreen on the PCB. You can bend the 2 outer legs of each

transistor, so it doesn't fall out when turning around the board.

The footprint is quite small, so stay focused and don't use too much solder to avoid shorts.

Check your solder joints with a magnifier and/or multimeter when in doubt.

STEP 6 (Main PCB)

IC sockets

IC Socket 14Pin

Oriantation is important to know how to place the ICs later! The notch should face upwards,

matching the print on the PCB.

You can use tape to hold them in place, put the other PCB on top, or bend 2 pins of each socket

inwards, so they don't fall when turning the board around. Then solder everything.

Page 6