CubuSynth Exhaust Oluşturma Kılavuzu - Sayfa 6

Müzik Pedalı CubuSynth Exhaust için çevrimiçi göz atın veya pdf Oluşturma Kılavuzu indirin. CubuSynth Exhaust 12 sayfaları. Expander module for the engine
Ayrıca CubuSynth Exhaust için: Kullanıcı Kılavuzu (5 sayfalar)

Sayfayı Yazdır

CubuSynth Engine - Build Guide

PCB V1.1 Jul 2022

STEP 5 (Main PCB)

Transistor

Take the 2N3904, put it in place and make sure the orientation is correct. The outline of the

transistor has to match with the silkscreen on the PCB. You can bend the 2 outer legs of each

transistor, so it doesn't fall out when turning around the board.

The footprint is quite small, so stay focused and don't use too much solder to avoid shorts.

Check your solder joints with a magnifier and/or multimeter when in doubt.

STEP 6 (Main PCB)

IC sockets

IC Socket 14Pin

Oriantation is important to know how to place the ICs later! The notch should face upwards,

matching the print on the PCB.

You can use tape to hold them in place, put the other PCB on top, or bend 2 pins of each socket

inwards, so they don't fall when turning the board around. Then solder everything.

Page 6