3D Systems Cubify CUBEX Duo 교체 매뉴얼 - 페이지 7
{카테고리_이름} 3D Systems Cubify CUBEX Duo에 대한 교체 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Systems Cubify CUBEX Duo 13 페이지. Replacing a main board pcb
3D Systems Cubify CUBEX Duo에 대해서도 마찬가지입니다: 교체 매뉴얼 (17 페이지), 매뉴얼 (10 페이지), 매뉴얼 (10 페이지)
페이지 인쇄
Installing the new print jet
1. Check your Print Jet is assembled and that the print tip moves freely when
pushed in and out of the drive. The Print tip moves freely for the levelling
process. Once the levelling process has been completed the Print tip will be
locked off.
If your Print Jet and print tip are not assembled together when you receive them, you
can assemble them by inserting the locating end of the Print tip into the Print Jet as
pictured below.
7