3D Systems Cubify CUBEX Duo 교체 매뉴얼 - 페이지 8

{카테고리_이름} 3D Systems Cubify CUBEX Duo에 대한 교체 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Systems Cubify CUBEX Duo 13 페이지. Replacing a main board pcb
3D Systems Cubify CUBEX Duo에 대해서도 마찬가지입니다: 교체 매뉴얼 (17 페이지), 매뉴얼 (10 페이지), 매뉴얼 (10 페이지)

3D Systems Cubify CUBEX Duo 교체 매뉴얼
2. Place the Print Jet onto the Print Jet carriage plate as pictured, note the
locating standoff and corresponding hole present on the Print Jet
3. Ensure that the wires from the Print tip are orientated to travel straight up to
the Sensor board
4. Replace the M3 x 20 bolt into the hole as pictured and fasten. This must be
tight.
8