3D Systems Cubify CUBEX Duo 교체 매뉴얼 - 페이지 10
{카테고리_이름} 3D Systems Cubify CUBEX Duo에 대한 교체 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Systems Cubify CUBEX Duo 13 페이지. Replacing a main board pcb
3D Systems Cubify CUBEX Duo에 대해서도 마찬가지입니다: 교체 매뉴얼 (17 페이지), 매뉴얼 (10 페이지), 매뉴얼 (10 페이지)
페이지 인쇄
Levelling the print tips for CubeX Duo/Trio
If your CubeX only has a single print jet please see section 'Fastening the print
tip on a CubeX'
1. Power on the CubeX printer
2. To clean the nozzles for levelling, put the CubeX printer into PJ-Control mode.
Heat all of the print jets EXCEPT for the new one to 230° and clean of any
plastic debris with pliers. Allow the Print Jets to cool down.
3. Put the CubeX printer into manual move mode.
4. Raise the print pad until it is approximately 5mm away from the print tips.
10