3D Systems Cubify CUBEX Duo Ersatz-Handbuch - Seite 10
Blättern Sie online oder laden Sie pdf Ersatz-Handbuch für 3D-Drucker 3D Systems Cubify CUBEX Duo herunter. 3D Systems Cubify CUBEX Duo 13 Seiten. Replacing a main board pcb
Auch für 3D Systems Cubify CUBEX Duo: Ersatz-Handbuch (17 seiten), Handbuch (10 seiten), Handbuch (10 seiten)
Seite drucken
Levelling the print tips for CubeX Duo/Trio
If your CubeX only has a single print jet please see section 'Fastening the print
tip on a CubeX'
1. Power on the CubeX printer
2. To clean the nozzles for levelling, put the CubeX printer into PJ-Control mode.
Heat all of the print jets EXCEPT for the new one to 230° and clean of any
plastic debris with pliers. Allow the Print Jets to cool down.
3. Put the CubeX printer into manual move mode.
4. Raise the print pad until it is approximately 5mm away from the print tips.
10