- ページ 10

3Dプリンター 3D Systems Cubify CUBEX DuoのPDF 交換マニュアルをオンラインで閲覧またはダウンロードできます。3D Systems Cubify CUBEX Duo 13 ページ。 Replacing a main board pcb
3D Systems Cubify CUBEX Duo にも：交換マニュアル (17 ページ), マニュアル (10 ページ), マニュアル (10 ページ)

ページを印刷する

1. Removing the Damaged Print Jet
2. Installing the New Print Jet

Levelling the print tips for CubeX Duo/Trio

If your CubeX only has a single print jet please see section 'Fastening the print

tip on a CubeX'

1. Power on the CubeX printer

2. To clean the nozzles for levelling, put the CubeX printer into PJ-Control mode.

Heat all of the print jets EXCEPT for the new one to 230° and clean of any

plastic debris with pliers. Allow the Print Jets to cool down.

3. Put the CubeX printer into manual move mode.

4. Raise the print pad until it is approximately 5mm away from the print tips.