Acoustic Energy Aego BT2 소유자 매뉴얼 - 페이지 7
{카테고리_이름} Acoustic Energy Aego BT2에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Acoustic Energy Aego BT2 12 페이지. Bluetooth loudspeaker
페이지 인쇄
If you connect an Android, Windows Mobile or Blackberry device, the volume control
will adjust when changed on the connected device but the volume cannot be raised
past the point where it has been set by the volume buttons on the top panel. If you
are routinely using a device that uses these operating systems, it will make sense to
raise the volume on the BT2 to its maximum setting and then use the volume on the
connected device to set the listening level.
B l u e t o o t h
7
The Bluetooth button will place the BT2 in pairing mode, ready to connect to a
Bluetooth device. If you are turning the BT2 on for the first time, or since you have
reset the speaker, it will automatically go into pairing mode and become visible to
Bluetooth devices around it. If a device you have previously connected to is present,
the BT2 will automatically try and pair with that. If you wish to disconnect the BT2
and connect a new device, press and hold the Bluetooth button for three seconds
(the blue pairing light will flash). This will end the connection between the two
devices and allow you to connect a new device to the BT2. Holding the Bluetooth
button for longer than four seconds will reset all the Bluetooth connections.
s tat u s l I g h t s
8
The BT2 has two lights that indicate the status of the unit and convey useful information.
The top light beneath the power button is the power status indicator. This will shine
a solid white colour when the BT2 is powered on and running on mains or with a
battery reserve of over 20%. If the battery level is below 20%, the light will turn red
(and the Charge Out socket will be disabled). If power drops below 5% the red light
will start to flash.
The lower light shows the status of the BT2. If the Bluetooth input is selected but not
connected, the light will flash blue. Once a connection has been made, the light will
go a solid blue. When the aux input is selected, the light will turn green.