3D Upfitters LulzBot Mini 2 R1 설치 매뉴얼 - 페이지 7

{카테고리_이름} 3D Upfitters LulzBot Mini 2 R1에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Upfitters LulzBot Mini 2 R1 18 페이지. Enclosure kit

Assemble Panels

The front panels are made from thicker 1/4" acrylic to provide more structural rigidity for the

doors. Do not try to bend the 1/4" acrylic!

1. Identify the Corner Connectors

Each of the corners on the enclosure will be held together by the connectors pictured below. There are

only two versions L and R, which can be identiﬁed by the letters stamped on the inside. The opposite

connectors are identical, i.e. Bottom Right is the same as Top Left. In all cases the surface of the

connector with the cutout pattern faces front or back.

Top Left

Bottom Left

2. Attach The Door Frame Corners 

The front door is designed so that the latches are on the top. Attach the door

connectors on the back side of the door frame using the provided cap head 12mm

screws. See the photos below. The top of the connector should be ﬂush with the top

of the acrylic.

Top Right

Bottom Right