3D Upfitters LulzBot Mini 2 R1 설치 매뉴얼 - 페이지 8

{카테고리_이름} 3D Upfitters LulzBot Mini 2 R1에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Upfitters LulzBot Mini 2 R1 18 페이지. Enclosure kit

Note there are also mid-panel connectors on the top and left

and right sides of the door frame. These should be attached

using M4 cap head 12mm screws.

3. Assemble Latch Mount

Locate the magnetic latch and use the wood

screws to attach it to the latch mount. Hand

tighten and make sure its secure, but do not

over tighten or the screws may strip. The latch

can be later adjusted front-to-back to make sure

the door is ﬂush with the door frame.

The assembled latch mount is attached to

the door frame via two M4 12mm cap head

screws at the bottom of the door frame as

shown to the right.