3d-printz Mini Sinbad 1200 매뉴얼 - 페이지 3

{카테고리_이름} 3d-printz Mini Sinbad 1200에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3d-printz Mini Sinbad 1200 6 페이지.

Assembling

seated, the Bowden cable tubes will help you and act as guide rails. But be careful not to

glue the bowdens to the fuselage parts, they should remain freely movable! Use some

activator to get a strong adhesive bond!

First check whether all parts according to

the list above are present and intact. If

necessary, sand off residues with

sandpaper and also roughen the adhesive

surfaces a little. The rudder hinges are still

a bit stiff due to production - move them

back and forth until they run smoothly, if

necessary sand them, but be careful! The

best way to assemble the fuselage is to

use the Bowden cable sleeves as guide

rails. Join Fus2, Fus3 and Fus4 in this way

and glue the parts over a large area with

medium-viscosity superglue! Make sure

that the individual parts are correctly