3d-printz Mini Sinbad 1200 Manuel - Sayfa 3

Oyuncak 3d-printz Mini Sinbad 1200 için çevrimiçi göz atın veya pdf Manuel indirin. 3d-printz Mini Sinbad 1200 6 sayfaları.

Assembling

seated, the Bowden cable tubes will help you and act as guide rails. But be careful not to

glue the bowdens to the fuselage parts, they should remain freely movable! Use some

activator to get a strong adhesive bond!

First check whether all parts according to

the list above are present and intact. If

necessary, sand off residues with

sandpaper and also roughen the adhesive

surfaces a little. The rudder hinges are still

a bit stiff due to production - move them

back and forth until they run smoothly, if

necessary sand them, but be careful! The

best way to assemble the fuselage is to

use the Bowden cable sleeves as guide

rails. Join Fus2, Fus3 and Fus4 in this way

and glue the parts over a large area with

medium-viscosity superglue! Make sure

that the individual parts are correctly