3d-printz Mini Sinbad 1200 Manuel

Oyuncak 3d-printz Mini Sinbad 1200 için çevrimiçi göz atın veya pdf Manuel indirin. 3d-printz Mini Sinbad 1200 6 sayfaları.

Mini Sinbad 1200

Rev 0.0 – 08.01.2021

3d-printz Original

Take-off-weight: ca. 400g (LW-PLA) ca. 700g (PETG)

Span: ca. 1200 mm

Airfoil: Original Sinbad / RG15

CG: 45 mm

additional Material:

RC-Components

Bowden

CA medium and thin viscosity

Cutterknife

Sandpaper

4mm Carbonrod

(2x 465mm forFloaterwing, 2x 360mm for Acro Wing,

1x 45mm, 1x 65mm for Wingmount)

3mm Carbonrod 105mm

2mm Carbonrod 230mm bzw. 45mm

some Lead

4 round Magnets 10x4mm

Plasticscrew M6

Screwnut M6

RC Components:

RC Receiver

Battery (f.e. NimH 400mah - AAA for Gliderversion)

2x or 4x Microservos

Trivia:

The Mini Sinbad was developed as an easy-to-fly slope glider. The possibility of flying it

with the slow original airfoil only with rudder or with the faster RG 15 wing extends its field

of application and provides variety. The slow flight characteristics are excellent and with

the faster wing the small vintage glider can also pick up speed properly.

The flight behavior benefits from low weight so LW-PLA is the best choice of material, but it

can also be printed with Standard PLA or PETG.