3d-printz Mini Sinbad 1200 Manuel - Sayfa 5

Oyuncak 3d-printz Mini Sinbad 1200 için çevrimiçi göz atın veya pdf Manuel indirin. 3d-printz Mini Sinbad 1200 6 sayfaları.

To assemble the wings, 2 carbon rods with a 4mm diameter are required (465mm for

Floaterwing and 360mm for Acrowing). The assembly is explained here using the example

of the floater wing, but works in exactly the same way for acrowing.

First insert the carbon rod into the Wingjoiner and carefully assemble one wing half without

glue. Check immediately whether the recess for the carbon rod is free, the manufacturing

process may cause small impurities to be present. This must be carefully pierced with the

rod. To do this, carefully twist and push the rod back and forth until the channel is free - but

be careful! The fit of the Wingjoiner in the Wingcenter should also be checked before

bonding and, if necessary, sanded down for a snug fit.

To do this, insert an M6 hexagon nut into the recess provided in the Wingadaptermount

and fix the wing from above with an M6 plastic screw. After the adapter and wing are

connected, the fit between the fuselage and wing can be tested and, if necessary, sanded.

The 2 tabs of the Adaptermount should slide into the corresponding recesses in the

fuselage with light pressure and then be secured with 2 carbon rods (4mm diameter). The

locking pins should have a snug fit with enough friction not to loosen in flight. Alternatively,

other types of security can also be used.

Last but not least, the parts cockpit, canopy, motorspant and Fus1 or motor nose are

beeing assembled as seen in the explosion view. To glue the canopy and cockpit at the

right angle, the fuselage itself can be used as a template - apply glue, position the parts

with the help of the fuselage and use the activator. 4 round magnets 10x4mm are used to

When everything fits, the carbon rod

can be inserted into the Wingjoiner and

the WingcenterL glued to the

Wingjoiner - it is best to use thick

superglue and apply it generously! Now

the wing can be glued part by part on

both sides, always making sure that the

surface segments are flush.

After the wings have been glued, they

can be screwed to the corresponding

Wingadaptermount

(„Flächenaufnahme) (attention - as with

the "Wingjoiner" part, there is also a

part for the floater and a part for the

acrowing).