3d-printz Nice 2000 매뉴얼 - 페이지 5

{카테고리_이름} 3d-printz Nice 2000에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3d-printz Nice 2000 6 페이지.

First glue wing1 – 5 and wingtip of one side together – !do not glue to the center part

to get a divisible wing!

Then glue the middle part of the wing, consisting of WingsmiddleL & R and Joiner:

Now one of the wing halves can be glued to the center section.

Finally, depending on whether all flaps are to be used or not, remove the small tabs

between the wing and aileron or flaps and sand them free with a thin file or a piece

of sandpaper and make them move smoothly by repeatedly moving them up and

down. The wing is attached to the fuselage with 2 M5 plastic screws!

Electronics

The Nice is designed for 12mm servos, just like

Savöx SH-0264MG

SG 90

or any

other servo with similar dimensions. For full controll you will need 6 of them.