3d-printz Nice 2000 매뉴얼 - 페이지 6

{카테고리_이름} 3d-printz Nice 2000에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3d-printz Nice 2000 6 페이지.

Battery:

3S Lipo, 2200mah, 25C

Motor:

Racerstar BR2212 1400KV

...or similar

ESC: any Micro ESC with BEC, 20A (make sure to choose a small one)

Prop: Foldingprop 8.5x7.5 (you can choose a

printable

one)

Throws

With the recommended CG at 50mm behind the leading edge you can use these

throws as a basic setup:

Aileron: +/- 20mm

Elevator: +/- 10mm

Rudder: Maximum

Camber (Thermik): -3mm

Speed: +2mm

Butterfly/Crow:

Flaps -25mm

Ailerons +20mm

Elevator -2mm

Please test the Butterfly/Crow in a good height before you try to land with it!

Center of Gravity

The right center of gravity is essential for comfortable flight behavior. This is

precisely why it should be dialed in individually. The initial value can be assumed to

be approx. 50 mm behind the leading edge. If more performance and more agile

flight behavior is desired, the center of gravity can be shifted further back, but the

throws should then also be adjusted.

Please note that the center of gravity and the throws have to be chosen by the pilot

himself for each Nice built - the values given here are only guidelines!

We wish you a lot of fun with your Nice!