3d-printz Nice 2000 매뉴얼 - 페이지 4

{카테고리_이름} 3d-printz Nice 2000에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3d-printz Nice 2000 6 페이지.

Stabilizer

First glue the rudder to the skid, making sure that no glue gets onto the movable

rudder surface. Then put the rudder on the protruding part of the 8mm carbon

fuselage tube and check for fit. Now the fin can be glued extensively with Fus5.

Glue the parts El_right, El_middle and El_left together, not forgetting the

controllsurface. The Elevator is secured with an M5 plastic screw which threads into

the M5 nut located in the pylon.

Wings

The wings are joined by a 1000mm long 8mm carbon tube in the front and a

185mm long 8mm carbon tube a little further back. When assembling the

wings, make sure they are glued flush. The carbon tube serves as a guide.