3d-printz Nice 2000 매뉴얼 - 페이지 2

{카테고리_이름} 3d-printz Nice 2000에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3d-printz Nice 2000 6 페이지.

Build

Fuselage

The heart of the fuselage is an 8mm carbon tube with a length of 775mm.

The parts Fus2 - 5 can be pushed onto the carbon tube and glued flush with CA -

make sure to pay attention to the alignment. It is advisable to insert the Bowden

cables into the channels provided in advance in order to have additional guide

rails. Gluing the carbon tube to the fuselage is not necessary! The tube ends flush

with Fus2.

https://youtu.be/vjD1EowaAx8

Insert two M5 nuts into the designated moulds in Fus2 and glue the joint plate to

Fus2, making sure you cover a large area with the CA. Then check the pylon for

correct alignment (El_middle serves as a reference) and glue it to Fus5.

Glue cockpit and cockpit1. Then fix the motormount in Fus1 with two pieces M3x8mm

and suitable nuts, push in the cockpit for testing purposes and then glue it flat to

Fus1. Motorholder is used as a stop, but should not be permanently glued.

Video:

https://youtu.be/0hcpaxl10hE