3DGence ONE 서비스 매뉴얼 - 페이지 4

{카테고리_이름} 3DGence ONE에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3DGence ONE 5 페이지. Z-axis limit switch adjustment
3DGence ONE에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지)

페이지 인쇄
3DGence ONE 서비스 매뉴얼
Z-AXIS LIMIT SWITCH ADJUSTMENT
3DGence ONE
9
Move the heatbed slowly to the front to such position that the hotend is above the front left corner of the heatbed
– be careful so the heatbed do not hit the hotend (hotend should be a few milimeters above the heatbed).
10
Adjust the distance between the nozzle and the heatbed with the knurled bolt to 0.8 mm by following steps:
– check the distance between the nozzle and the heatbed using a feeler (or typical credit card). It should be 0.8 mm,
– when the distance is more or less than 0.8 mm, adjust it manually using the knurled bolt – turn the knurled bolt
in the appropriate direction (we recommend not more than a half of turnover – for safety),
01.2018
3DGence ONE | support: +48 32 438 98 64 | www.3dgence.com
3/4