3DGence ONE 서비스 매뉴얼 - 페이지 5
{카테고리_이름} 3DGence ONE에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3DGence ONE 5 페이지. Z-axis limit switch adjustment
3DGence ONE에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지)
페이지 인쇄
Z-AXIS LIMIT SWITCH ADJUSTMENT
3DGence ONE
– base Z axis in order to check the location of the nozzle by using the Home Z command,
– check the distance between the nozzle and the heatbed using the feeler (or credit card). It should be 0,8 mm,
– repeat these steps until the distance between the nozzle and the heatbed will be 0.8 mm.
11
Check if the distance in all four corners is 0.8 mm by manual movement of the heatbed and the hotend to all corners.
– if the distance is maintained, tighten the screw from Z-axis slider (1) and again check the distance in all corners.
Then run Heatbed Scan by choosing the following commands from printer's menu:
OK
Calibration
– if the distance is not within the range of 0.7 mm to 0.9 mm – contact the 3DGence service.
01.2018
Heatbed Scan
3DGence ONE | support: +48 32 438 98 64 | www.3dgence.com
4/4