3DHS SLICK 580 조립 설명서 - 페이지 4

{카테고리_이름} 3DHS SLICK 580에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3DHS SLICK 580 16 페이지.

-Masking tape

-Hobby knife with #11 blades

-Razor saw

-Thin and medium CA.

-Blue Loctite.

-Silicon based glue (Zap-A-Dap-A-Goo, etc.)

-Electric drill with an assortment of small drill bits.

-Small flat head and Phillips head screw drivers.

-Standard and needle nose pliers.

-Metric balldriver or allen key set.

-4 sub micro metal geared servos. All flight testing was performed with Hitec HS-65MG

and HS-5065MG digital servos and we strongly recommend the use of either of these high

quality servos.

-Torque 2818T/900 Brushless Outrunner motor.

-Airboss Elite 45 Amp ESC.

-3S 2100-2700 mah LiPo battery.

-APC 12x6 E prop (NOT the slow fly version!).

-52 mm Extreme Flight spinner.

-1 18"-24" extensions for the elevator servo and 2 6"-8" extensions to go between the

receiver and the aileron servo leads. We recommend the 28 or 32 AWG extensions to save

weight.

-Adhesive backed Velcro and Velcro strap for battery retention.

Let's begin!