Alto Professional TrueMix 600 사용자 설명서 - 페이지 15

{카테고리_이름} Alto Professional TrueMix 600에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Alto Professional TrueMix 600 20 페이지.

(4.0) OPERATION

(4.2) Connecting a Bluetooth Device

Press and hold the Bluetooth button for 3 seconds, then release it. TrueMix 600

will go into Bluetooth pairing mode and the blue LED will begin flashing

repeatedly. Bluetooth pairing will time out after 2 minutes if no device is

connected.

Note: Pressing the Bluetooth button again during pairing process before a

device is paired will cancel the pairing process.

2. Navigate to your Bluetooth device's setup screen, find the device named

"TrueMix 600" and connect.

3. When paired successfully, the blue LED will illuminate solid.

Note: If your Bluetooth device prompts that a pairing code is required, use

"0000".

4. Turn up the volume on your Bluetooth device and then turn up the Bluetooth

volume knob. If signal distortion occurs, turn down the volume on your Bluetooth

device.

To disconnect a paired device, press and hold the Bluetooth button for 3 seconds.

The next time Bluetooth pairing is activated, TrueMix 600 will try to connect with

the last device that was paired with it. If after 2 minutes the last paired device is

unavailable, it will go into standby mode until you initiate a new device pairing.

Notes:

1. The TrueMix 600's Bluetooth memory can store up to 5 user devices.

2. Pressing and holding the Bluetooth button for 10 seconds while a device is

paired will unpair the device and remove it from memory.

Interfacing with Bluetooth Calls:

TrueMix 600 has a special feature for use with Bluetooth-connected smartphones

called Mix-Minus Return. This feature allows you to send signal from the Mic/Line

inputs to a connected smartphone without generating feedback or echo from

incoming call audio. This is useful for cleanly recording a remote phone call for a

podcast or radio show.

To send a Mic or Line signal to a Bluetooth-connected smartphone, turn up the

Aux Send knob on the channel you want to send to set the desired signal level to be

received by the phone.