3DP Workbench 매뉴얼 - 페이지 8
{카테고리_이름} 3DP Workbench에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3DP Workbench 12 페이지. Moving and folding the gantry
페이지 인쇄
3DP Moving and Folding the Gantry
Approved By:
Date: <6/14/2016>
Page 7 of 11
Step 6: Remove the filament guide rod.
Disconnect the filament sensor wire and the Heated bed light.
Loosen the filament guide rod holder so you can slide the rod out from the base unit.
Gently remove the rod from the holder leaving the clamp system attached to the cabinet
handle. Set rod aside for later replacement.
WI XXXX-xxxxxx– 3DP Moving the Printer