3DUpFitters Ender 3 V2/CR-6 Enclosure Kit 설치 매뉴얼 - 페이지 12

{카테고리_이름} 3DUpFitters Ender 3 V2/CR-6 Enclosure Kit에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3DUpFitters Ender 3 V2/CR-6 Enclosure Kit 15 페이지.
3DUpFitters Ender 3 V2/CR-6 Enclosure Kit에 대해서도 마찬가지입니다: 설치 매뉴얼 (16 페이지)

페이지 인쇄

6. Install Vent

You should now place the enclosure over

the 3D printer.

The fresh air vent is inserted from the

outside and attached using M4 12mm

screws. This will bring in cold air to the

air intake vent of the case, cooling the

electronics inside. It's important to keep the fan on the back panel running in order to

help draw air through the case's vents and to the outside.

Note that the lid ﬁts right into the vent slots, helping to form a seal.