3DUpFitters Ender 3 V2/CR-6 Enclosure Kit Manual de instalação - Página 12

Procurar online ou descarregar pdf Manual de instalação para Impressoras 3D 3DUpFitters Ender 3 V2/CR-6 Enclosure Kit. 3DUpFitters Ender 3 V2/CR-6 Enclosure Kit 15 páginas.
Também para 3DUpFitters Ender 3 V2/CR-6 Enclosure Kit: Manual de instalação (16 páginas)

6. Install Vent
You should now place the enclosure over
the 3D printer.
The fresh air vent is inserted from the
outside and attached using M4 12mm
screws. This will bring in cold air to the
air intake vent of the case, cooling the
electronics inside. It's important to keep the fan on the back panel running in order to
help draw air through the case's vents and to the outside.
Note that the lid fits right into the vent slots, helping to form a seal.
Copyright 2021 3DUpfitters
12