3DUpFitters Ender 3 V2/CR-6 Enclosure Kit Руководство по установке - Страница 12

Просмотреть онлайн или скачать pdf Руководство по установке для 3D-принтеры 3DUpFitters Ender 3 V2/CR-6 Enclosure Kit. 3DUpFitters Ender 3 V2/CR-6 Enclosure Kit 15 страниц.
Также для 3DUpFitters Ender 3 V2/CR-6 Enclosure Kit: Руководство по установке (16 страниц)

Печатать страницу

6. Install Vent

You should now place the enclosure over

the 3D printer.

The fresh air vent is inserted from the

outside and attached using M4 12mm

screws. This will bring in cold air to the

air intake vent of the case, cooling the

electronics inside. It's important to keep the fan on the back panel running in order to

help draw air through the case's vents and to the outside.

Note that the lid ﬁts right into the vent slots, helping to form a seal.