Altocraft 240-2087 운영자 매뉴얼 - 페이지 6

{카테고리_이름} Altocraft 240-2087에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Altocraft 240-2087 10 페이지. 8-1/4 inch compound miter saw

페이지 인쇄

OPERATING PROCEDURES

5. To begin cutting, lower the cutting head. The movable guard opens automati-

cally.

6. After cutting, allow the head to come back up. The guard will close automati-

cally.

7. The saw will stop when you release the trigger switch.

MODES OF USE

Chop cut:

The head is locked in the upright position. The table rotation is locked at 0°.

This is a good setting for simple 90° crosscuts.

Miter cut:

The head is locked in the upright position. To unlock the table rotation, unscrew the

locking handle and press on the miter detent spring lever

with your thumb Move the table rotation to the left or right up to 45° left & 52° right.

The miter detent spring lever , if released, will stop the table at detents

at 0°, 15°, 22.5°, 30°, & 45° left and right. Use the locking handle to

lock the table at the desired angle, especially those in between the detents.

Bevel cut:

To unlock the head angle (bevel) adjustment, loosen the bevel lock handle

at rear of the saw. Lock it when the blade is tilted at the desired angle.

The table rotation is locked at 0°.

Compound cut:

Unlock and move the table rotation to the left or right as in miter cuts above. Using

the lever at the back of the saw, unlock the head and bevel it to any position from

0° – 45° left, then lock it in place.

NOTE: At extreme positions, the hold-down clamp should be moved to the right

side of the table to prevent interfering with the movement of the cutting head.

Always check before making the cut if there is any potential interference from the

clamp or any other part of the machine.

MAINTENANCE

NOTE:

ven though the angles are marked on the machine, it is always a good

idea to check them by making a trial cut. See Aligning Miter and Bevel, be-

low.

 Inspect the cord regularly and have it replaced by an authorized repair facility if

it is damaged.

 Check the brushes occasionally (after about 50 hours of use) and replace if

worn. The brushes can be replaced by removing the motor cap.

The brushes and their springs could jump out of the holders- be careful

not to lose them. Inspect the brushes. If the contact surface is not

smooth, or it is worn or heavily used, replace both brushes. Insert the new

brushes and springs in their holders and re-fasten the cap.

 The plastic kerf plate table insert should be replaced if damaged to reduce the

risk of chips lodging in the slot and catching in the blade.

 Keep the vents clear of dust and debris. This will help prevent possible electri-

cal shorts and ensure proper cooling.

 Keep the tool housing and handle clean and free of oil and grease by using mild

soap and a damp (not wet) cloth.