ClearView Easy Slide 설치 및 사용 설명서 - 페이지 3

{카테고리_이름} ClearView Easy Slide에 대한 설치 및 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ClearView Easy Slide 6 페이지.
ClearView Easy Slide에 대해서도 마찬가지입니다: 조립 지침 매뉴얼 (16 페이지)

페이지 인쇄

Easy Slide handle assembly

IMPORTANT

The Easy Slide must be bolted to a drawer top or partially secured to a workbench via clamps at the rear

to enable safe lowering of the fridge tray during handle assembly.

Do not attempt to lower the fridge tray prior to securing the Easy Slide, as components are under pre-load

pressure from gas struts and a considerable downward force on the handle will be required.

1. Place the Easy Slide on the vehicle drawer system, positioned roughly in place.

2. Release the Easy Slide Transit Lock by pushing the centred yellow lever towards the right.

3. Free the fridge tray assembly for movement by simultaneously pressing down both yellow levers on

bearing runner, at the same time slide the tray assembly forward slightly to reveal rear fixing holes on

Easy Slide base plate.

4. Using timber screws provided, temporarily fix the rear of the Easy Slide to the top of your drawers.

5. Once the Easy Slide is secured, bring the tray assembly to full extension. An audible "click" can be heard

when rail lock out mechanism is engaged.

6. Place plastic chocks on the back edge of the fridge tray. This will be required to hold the tray in a

lowered position.

7. Manoeuvre the handle arms so that notches at the base of arms lines up with pivot bolt found on

strut fixing plate. This bolt will act as a temporary pivot point for lowering the fridge tray.

8. Lower the fridge tray by pushing down on the handle, until top groove of plastic chocks slips under

the back edge of the tray assembly frame. A moderate amount of downward force is required when

the Easy Slide is empty. The plastics chocks will prevent fridge tray from lifting back up.

9. Release handle and manoeuvre the arms until bolt holes on arms align with threaded fixing points.

Secure the arms with M10 bolts and washers, using 6mm Hex Key.

10. Cut cable tie around handle trigger to enable cog lock mechanism. Squeeze trigger and push down

on handle to lower fridge tray assembly and release plastic chocks. Remove plastic chocks and

release handle trigger to engage the cog lock.

11. Test your Easy Slide to ensure cog lock mechanism works correctly and engages in every available

position. If all working correctly, return the Easy Slide to the stowed position and re-engage the

Easy Slide Transit Lock.

Page | 3

Due to Clearview Continuous Improvement Program, information may change without notice.

Clearview takes no responsibility for the result of incorrect use of these installation instructions.