ClearWater Lights Darla 설치 매뉴얼 - 페이지 9

{카테고리_이름} ClearWater Lights Darla에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ClearWater Lights Darla 12 페이지. Led light kit for bmw k1600gt
ClearWater Lights Darla에 대해서도 마찬가지입니다: 설치 매뉴얼 (12 페이지), 설치 매뉴얼 (12 페이지), 설치 매뉴얼 (12 페이지), 설치 매뉴얼 (16 페이지)

페이지 인쇄

Finishing the Install

Note: Bike engine must be running for lights to work.

To finish the install of your Clearwater Lights, verify that all wires are routed

away from pinch points, steering stops and direct contact with heat sources.

Insert the fuse into the fuse holder and start the engine to activate the

Clearwater Lights. Reference the CANopener manual for programmability

and functionality of the lights. Make sure that all functions such as high

beam, horn, and dimming modes work as expected.

Once the system is confirmed working, reassemble the bike including the

fairings, turn signal connector and seat. You can now level the lights to

minimize unneccessary glare to oncoming traffic.

Aligning the Lights:

Ask an assistant to help you with this

procedure. Make sure the bike is on

level ground and have an assistant sit

on the bike. With a right angle board

or object, position the board on the

floor and slide it up to the light.

The goal is to adjust the lights so that

the light is level with the ground.

Do Not Kink The

Grommet

To maintain the

integrity of the water

sealling grommet,

do not kink, deform

or put pressure on

the grommet when

dressing the wires

during install of

Clearwater Lights.

Do Not Kink The Grommet

Page 8