Custom Crimp CC400 운영자 매뉴얼 - 페이지 6

{카테고리_이름} Custom Crimp CC400에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Custom Crimp CC400 17 페이지. Dial micrometer style adjustment
Custom Crimp CC400에 대해서도 마찬가지입니다: 운영자 매뉴얼 (18 페이지)

페이지 인쇄

CC200 / CC400

• Dies are available for the CC200 crimper in 84S, 99S and 130S Series

• Dies are available for the CC400 crimper in 84S, 99S and 145S Series

• A set of 130mm O.D - 99mm I.D. Intermediate Dies is furnished with the

CC200 crimper.

• A set of 145mm O.D - 99mm I.D. Intermediate Dies is furnished with the

CC400 crimper.

The I.D. of the intermediate die must match the O.D. of the hydraulic die or

accurate crimps are not possible.

INDUSTRIAL DIE INSTALLATION

INTERMEDIATE ADAPTER DIE INSTALLATION

Turn on the crimper at the master power switch.

Bring the master dies to the full open position as shown in photo A, or to the

position where the die removal tool can be inserted to release the retaining

spring.

Insert the die removal tool in the release hole to release the retaining spring

as shown in photo B.

Attach either an Intermediate Adapter Die or an Industrial Die to the Master

Die as shown in photo C.

Note: The numbers stamped on the face of the die should face the operator.

Note that on some crimpers the master dies must be slightly closed in order

to completely insert the die removal tool.

Mount all 8 dies in a similar manner as shown in photo D.

If 130mm O.D. Dies are being used, proceed to crimping

Operating instructions and set up the crimper for the correct

crimp diameter.

If Hydraulic Dies are being used, see Hydraulic Die Installation

instructions.

General Production Hose Crimper

DIE SET UP AND INSTALLATION