Custom Crimp CC400 운영자 매뉴얼 - 페이지 9

{카테고리_이름} Custom Crimp CC400에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Custom Crimp CC400 17 페이지. Dial micrometer style adjustment
Custom Crimp CC400에 대해서도 마찬가지입니다: 운영자 매뉴얼 (18 페이지)

페이지 인쇄

CC200 / CC400

CRIMPING

Select the correct die for the combination of hose and ﬁ tting being

crimped. Consult the hose and ﬁ tting manufacturer's speciﬁ cations

for the correct die to use and the ﬁ nal crimp diameter required.

The ﬁ nal crimp diameter will be the closed diameter stamped on the

face of the die plus the number shown on the micrometer gage. See

the micrometer setting example below:

Micrometer Setting Example

Each 100 on the micrometer dial represents 1 mm above the

closed diameter of the die set. For example, with a 57mm

die set installed and the micrometer set at 240 as shown in

the photo, the ﬁ nal crimp diameter would be 59.4 mm ( 57mm

+ 2.4mm)

Insert the hose and ﬁ tting in the crimper head to the correct depth

and press and hold the foot switch until the crimper shuts off. If the

AccuStop

coupling stop is being used make settings according to

instructions.

Check the ﬁ nished crimp diameter with calipers to be certain that it is

within the hose manufacturer's speciﬁ cations.

CALIBRATION

Due to physical variations in hose and ﬁ tting combinations, it may be

necessary to offset the crimper in either the plus or minus direction by

a few mm to get the measured crimp diameter to match the micrometer

setting. If the ﬁ nal crimp dimension is consistently off in either direction

the micrometer dial can be adjusted to compensate.

Make a crimp with the hose and ﬁ tting combination most commonly

used, and measure the ﬁ nished crimp diameter.

If necessary, loosen the set screw on the adjustment knob with a .050'

hex key wrench.

Rotate the adjustment knob so that the number on the dial matches

the actual diameter of the ﬁ nished crimp.

Tighten the set screw and make another crimp to conﬁ rm that the

crimper is set correctly.

General Production Hose Crimper

CRIMPING / CALIBRATION

Set Screw (.050 hex wrench)