DK-TEC SPCPR150 사용자 설명서 - 페이지 10

{카테고리_이름} DK-TEC SPCPR150에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DK-TEC SPCPR150 12 페이지. 15 hp wood chipper with electric start

페이지 인쇄

Problem

The chipper does not do the

job correctly: the wood is not

pulled in by the machine itself.

The tile is not the same size.

The engine does not start/ the

engine switches itself off

When blocking the rotor. The

engine will not start because

the rotor is stuck

5. Troubleshooting

Cause

- The blades are too worn

- The diameter of the

branches inserted into the

machine is too large

- There is too much

distance between the fixed

blade and the counter

knife: the correct distance

is 0.5 mm (half a

millimeter)

- Electrical problem

with the motor

- There is no fuel on it

- There is no or not enough oil

on the engine (the oil must be

level with the thread on the

level screw)

- The diameter of the branch

is too large

- There are unacceptable

materials such as stone or

metal in the inlet pipe

Solution

- Change or sharpen the

blades. Note that the blades

are sharpened on both sides

so they can be turned.

- Switch off the engine and

remove the branch that is

too thick and adjust the gap

between the knife and

counter knife.

Check that

- The inlet pipe is fitted

correctly and that the bolts

are tight

- Press the 'start' button on

the engine

- Deactivate the

emergency switch (turn

the knob)

- Check the oil and fuel

level

- Contact

your

workshop.

Important:

Retighten bolts and blades

- Switch off the engine,

remove the spark plug cap

and turn the rotor counter-

clockwise. Use a wooden

stick to twist the rotor free and

to remove the material from

the rotor and inlet tube.

If necessary, remove the cap

from the bearing housing and

rotate the rotor shaft.

Check the sharpness of the

knives and counter knife and

replace them if necessary.

Important: Retighten bolts and

blades.

01/2020

service