Alumax ProLine PL50 설치 지침 매뉴얼 - 페이지 6

{카테고리_이름} Alumax ProLine PL50에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Alumax ProLine PL50 8 페이지. Frameless sliding enclosure

Place the two Bottom Seals [P] over the bottom of both door

panels. One seal needs to be positioned with the sweep leg is

on the same side as the roller. The other seal should be installed

with the sweep leg on the side with the cap cover.

Push the stoppers to the outside of the bar, on both ends. You

will need to hang the interior door panel first. It is the panel

that, when held, has the rollers near you and the sweep leg of the

bottom seal on the opposite side. Lift the rollers above the bar and

making sure that the bottom engages the center guide, lower the

interior panel onto the header bar. Repeat for the exterior panel.

Install the 4 lower roller assemblies at this point. Before fully

tightening the roller screws, rotate the cap to raise the roller until

it contacts the bottom of the bar. Using an allen wrench in the hole

on the edge of the roller cap may help.

Page 6 of 8