Alumax ProLine PL50 설치 지침 매뉴얼 - 페이지 8

{카테고리_이름} Alumax ProLine PL50에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Alumax ProLine PL50 8 페이지. Frameless sliding enclosure

Insert the wrench (in the towel bar box) into the

small hole on the edge of an end cap and rotate in

a clockwise direction until tight. Repeat for all remaining end

caps.

Move the exterior panel until it just touches the L

jamb on the side determined in step 10. Slide the

bumper over until the rubber contacts the roller wheel.

Tighten the Stopper Set Screws [X] on the bottom until

tight. Move the exterior door to the opposite wall until it

is approximately 1/4" from contacting the wall. Slide the

stopper over until it contacts the roller wheel and tighten the

set screws on the bottom. The stoppers for the interior panel

will be set in the same fashion.

Page 8 of 8