Alumax ProLine PL50 설치 지침 매뉴얼 - 페이지 7

{카테고리_이름} Alumax ProLine PL50에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Alumax ProLine PL50 8 페이지. Frameless sliding enclosure

For maximum water-proofing, the interior panel

should always be positioned closest to the shower

head, as shown in this illustration.

The vinyl L Jambs [Q] are installed on the outside

of both door panels. The walls need to be clean

and free of any dust. Use a pencil to lightly mark where

the exterior edge of the glass meets the wall to use as a

guide. To install the two L Jambs, peal the red tape off the

mating surface and stick them to the walls, oriented as

shown. Press the mating surface firmly to the walls down

the entire length of the L Jamb.

Locate the four, large hole, plastic washers [R] and

place them over the threads and flush with the

four end caps [S]. Next, place the four Plastic Inserts [T]

onto the four end caps and flush with the plastic washers.

The towel bars [U] will be installed on the same side of

the panels as the roller covers. Insert the threaded portion

of an end cap through one of the holes in a glass panel,

making sure that it is located on the same side as the

roller covers. Place a Small Hole Plastic Washer [V] and a

Metal Washer [W] on the end cap threads. Now, loosely,

thread the towel bar onto the exposed threads of the end

cap. Make another end cap assembly, and thread into

the other end of the towel bar. Repeat this process for the

other glass panel.

Page 7 of 8