Artopex e-Motion 사용자 설명서 - 페이지 4

{카테고리_이름} Artopex e-Motion에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Artopex e-Motion 10 페이지. Two-leg adjustable table

Reset and Memory Settings

Reset (Initialization)

Clear any obstructions below the surface. Press and hold the DOWN button on the keypad until the

table reaches its lowest height, stops, and rises slightly again. The display will momentarely indicate

"rES" and then indicate the actual height. The table has been reset and is now ready to use.

Procedure to raise or lower the work surface

After reset, press and hold the UP button, lifting column will rise, release to stop at the desired height.

After reset, press and hold the DOWN button, lifting column will lower, release to stop at the desired

height.

Position the work surface using the UP/DOWN button to desired height, press M button ﬁrst, then

press button 1, 2, 3 or 4.

When setting the memory positions, ensure there is at least a 1'' (25 mm) space

left between the work surface and any obstacle (such as chair armrests).

To raise or lower the work surface to a programmed position, press one of the four previously

programmed positions (1, 2, 3 or 4). The work surface will raise or lower to the programmed position.

Lock: Press simultaneously the UP and DOWN buttons for 5 seconds; keypad will lock and Loc will be

displayed (ﬂashing).

Unlock: Keep pressing simultaneously the UP and DOWN buttons for 5 seconds, to unlock the keypad.

Keypad will display current height

1 800 378-0189